Hello,
I'd like to build an XC-2 and XC-1A into a small case and connect them via XLink ports. No specific application in mind at this point, other than having a development platform which combines the capabilities of both. The questions I have are:
- What would be the "best" general configuration in terms of connecting ports and would I need to use pull-up resistors etc.
- Could this setup be configured such that I could write to the XC-2 flash storage without the need for plugging a USB adapter into its XSYS port. Or to put it another way, can the boards be wired together such that XC-2 flash is accessible via the XC-1A USB?
Cheers,
Andrew
Connecting an XC-2 and XC-1A.
-
- Member
- Posts: 10
- Joined: Wed Apr 28, 2010 3:07 pm