Hi,
I would like to use a XC-1A board as add-on card on a bigger
I/O board, all 16-pin headers will be connected via short
flat ribbon cables, and I want draw power from a 24V/5V
dc-dc converter.
Is it possible and save to feed in +5V and GND through the ports
(since I want to avoid the usage of the regular power plugin),
or can this cause potential problems like ground loops etc?
Thanks for your advice
XC-1A Power Supply
-
- Active Member
- Posts: 62
- Joined: Sat Sep 17, 2011 12:05 pm
-
- Experienced Member
- Posts: 75
- Joined: Thu Feb 02, 2012 3:32 pm
i've powered it with 5V from the prototyping area as well as the ports and not had a problem. it will work but i dont know if it's recommended.