Hi, i have problems with the :
Illuminate multiple LEDs in sequence or another way on an XS1-L2 MC board example ?
Illuminate multiple LEDs problem
-
- Active Member
- Posts: 43
- Joined: Sat Sep 29, 2012 8:38 am
-
- XCore Addict
- Posts: 133
- Joined: Tue Dec 15, 2009 10:23 pm
Hi!
Can you be more specific? What kind of problem? Does it not compile? Do the leds not light up?
Yvo
Can you be more specific? What kind of problem? Does it not compile? Do the leds not light up?
Yvo
-
- Active Member
- Posts: 43
- Joined: Sat Sep 29, 2012 8:38 am
thank you i found it from forum. and it work well
-
- Active Member
- Posts: 43
- Joined: Sat Sep 29, 2012 8:38 am
there is a firmware named usb_audio.xe can i see its full source?
-
- Active Member
- Posts: 43
- Joined: Sat Sep 29, 2012 8:38 am
Thank you
Other quest
There is "USB-Audio-2.0-XS1-L2-Binary(5.3)[11.2.0]" xe firmware demonstrated by XMOS.
This is best way to study that how we get audio data signal on a pin from a source and how to transmit to computer audio device by USB interface. These are all written in this binary i guess.
- I can not open and see whole source code in it. How can i do it?
- If i cant , can i download its whole source from your site? then how or give me please..
Other quest
There is "USB-Audio-2.0-XS1-L2-Binary(5.3)[11.2.0]" xe firmware demonstrated by XMOS.
This is best way to study that how we get audio data signal on a pin from a source and how to transmit to computer audio device by USB interface. These are all written in this binary i guess.
- I can not open and see whole source code in it. How can i do it?
- If i cant , can i download its whole source from your site? then how or give me please..